When temperatures are steadily dropping, and before you know it, you’ll be turning on your furnace for the first time this season. Most of the time, it will switch on without a hitch, but what if your furnace won’t turn on? Are you aware of what to do if your furnace won’t turn on? You could search for heating repair in Marysville if required. But first, let’s look at the reasons.
7 Reasons Why Your Furnace is Not Kicking On
-
Fuse Blown
Your furnace generates heat with gas, but it also circulates air around your home with electricity. If your furnace’s fuse is blown, your device will not operate. Examine your fuse box and check if your furnace’s switch is in the “on” mode, or you can simply search for a heating replacement in Marysville.
-
The Air Filter is Clogged
A dirty air filter, as we described earlier this week, can cause a variety of issues with your furnace. These issues can sometimes cause your furnace to stop working and refuse to restart. Make sure your filter is clean, and get in touch with HVAC technicians if your device still won’t switch on after you replace it.
-
No Power
Whether electricity or gas, the furnace still requires power to work. If it won’t turn on, look for a blown circuit breaker and make sure no connected wires have been eaten through by mice or gotten rusted. In such cases, it is best to call for heating repair.
-
Broken Pilot Light
If you have an outdated furnace with a gas-lighted pilot light, make sure the flame is ignited. Your furnace will not burn properly if the pilot light has been blown out. To understand how to relight your pilot light, consult your manufacturer’s instructions, and contact your local HVAC experts if it persists in blowing out.
-
Problems With the Thermostat
There is some home repair that can be done before calling for service. The first step is to double-check the thermostat to ensure that it is set to “heating” and that the temperature is high enough to turn it on. If the thermostat says “fan,” make sure it’s set to heating. In the winter, this is a regular procedure that gets overlooked.
-
The Gas Valve is Removed
During the summer, the gas valve to your furnace may have been switched off as a safety precaution. Check that it is in the “on” mode so that your furnace receives a supply of gas.
-
Condensation Issues
The furnace has a condensation pan that collects extra water, and if the tank is full, the furnace will not turn on. Merely draining the pan isn’t a feasible remedy (though it may help momentarily) because it doesn’t address the underlying concerns. It is possible that clogs are stopping the water from draining, or that the condensation removal motor has failed.
When Should You Seek Professional Help?
If none of the domestic troubleshooting techniques work, some concerns may require a service appointment for the best heating installation in Lynnwood.
Other technical difficulties could be causing your furnace to go into dormancy. It’s better to be safe than sorry. Contact 1st Response Heating & Air Solutions for the best furnace repair service.